Design for Manufacturing Excellence
We believe the best manufacturing starts at the design stage. Our engineering team helps you migrate from breadboard to industrial-grade PCB, optimise BOMs for cost and availability, and write the firmware that brings it to life.
We design boards that are easy to build, test, and scale.
Active component lifecycle management during design phase.
What We Do
We are not just a design house; we are a manufacturing company that designs. This means every trace layout, every component selection, and every mechanical tolerance is chosen with the factory floor in mind.
Our collaborative process ensures that by the time you reach the prototype stage, the hard work of ensuring manufacturability is already done.
Engineering Workflow
A structured approach to convert early concepts into stable, production-ready designs.
Requirements Capture
Defining technical specs, environmental constraints, and target BOM cost.
Schematic Capture
Component selection and logical circuit design using Altium or KiCad.
PCB Layout
Placement, routing, and stackup design with signal integrity in mind.
DFM & Simulation
3D interference checks and manufacturing rule compliance verification.
Prototyping
Rapid build of first-article units for functional validation.
ToT & Handoff
Full Transfer of Technology including Gerbers, BOM, and Source Code.
Tools & Technologies
We use industry-standard tools to ensure your design files are compatible, maintainable, and professional.
PCB Design: Altium Designer, KiCad, Cadence
Mechanical: SolidWorks, AutoCAD
Firmware: ST CubeIDE, ESP-IDF, Keil
Simulation: LTSpice, HyperLynx
Analogue & Power Management Design
RF & Wireless Connectivity (BLE, Wi-Fi, LoRa)
Design Services
End-to-end design engineering services to make your products manufacturing-ready.
Schematic & PCB Layout
High-speed digital, mixed-signal, and power electronics design using Altium Designer and KiCad.
Embedded Firmware
Bare-metal C/C++ and RTOS development for STM32, ESP32, Nordic, and TI microcontrollers.
DFM & DFA Analysis
Proactive pre-production review to optimize panelization, reduce BOM cost, and improve yield.
Mechanical Design
Industrial enclosure design (IP-rated), thermal simulation, and 3D printing validation.
Reverse Engineering
Legacy system modernization, BOM obsolescence recovery, and schematic recreation from physical boards.
Prototyping & Bring-Up
Rapid V1 build, board bring-up, signal integrity measurement, and functional validation.
Ready to make your design manufacturing-ready?
Share your schematics, PCB layouts and BOM. Our engineering team will respond with a structured DFM/DFT review, risk highlights and optimisation recommendations.